HTC4000 TEMPERA
TURE CONTROLLER
www.teamwavelength.com
© 2012
HTC4000-62400-B
PAGE 14
HTC4000: PCB & HEATSINK MOUNTING
To mount the HTC4000 to the heatsink and optional evaluation PCB, refer to the drawings and instructions
below:
Begin by applying thermal grease to the back
of the HTC to ensure good thermal contact.
We recommend Wavelength Electronics part
number THERM-PST.
MOUNTING INSTRUCTIONS
1. Feed the HTC pins through the large opening
in the HTCEVALPCB board so that the HTC
pins are on the top side of the evaluation
board and the mounting tabs are against the
back side of the board.
2. Line up the heatsink holes behind the HTC
and insert the screws through the evaluation
board and HTC unit into the tapped heatsink
holes.
3. Line up the HTC pins on the solder pads on
the evaluation board and tighten the screws.
4. Solder the HTC pins to the solder pads.
NOTE: Do not exceed 700°F soldering
temperature for more than 5 seconds on any
pin.
If the HTC is to be used without the HTCEVALPCB
board, apply the thermal grease as directed, line
up the screw holes in the HTC and heatsink and
attach with the supplied screws. Connect the
HTC pins to your system by soldering them to
the appropriate leads.
