8
First, download the Wave app and make sure that both GO X units
are set up to boost your carrier.
Note: only
one device
(your phone or tablet) can connect to
one
Cel-Fi GO X
via Bluetooth at a time. But don’t worry – every device
in the building will see better cellular signal, the Wave app is only
used to change settings and monitor the GO X's.
It's important that both GO X's share the same settings
. Any time
you make a change to one GO X, make sure to mirror that to both.
1
Download the Wave app at
waveform.com/waveapp
.
2
Open the app while keeping your phone within 4 feet of both
GO X units to start pairing. This may take a few minutes. The app will say “searching” and then
allow you to select a system to connect to.
Select either of the devices and hit "Connect".
Don't select "Remember this device" to make switching between GO X's easier. If you have
remembered a GO X, hit "Forget device" on the homescreen to go back to device selection.
3
Your GO X's are preprogrammed to boost Verizon.
If you're with a different carrier, go
to “Settings” and then the “Operator” section and change it. Changing carriers takes a few
minutes - don’t turn off your booster or move your phone away during the process.
Note for AT&T customers
:
if there is 4G LTE signal outdoors, choose “AT&T LTE Preferred”.
This will ensure that the GO X boosts as many LTE bands as possible, instead of boosting 3G.
4
Now connect to your second GO X by tapping "Connect to another system"
on the
dashboard, select the other serial number, and repeat step 3 to set the carrier. Before
switching, it's helpful to memorize the last couple digits of the serial number of the device
you were just connccted to, so that you can be sure to select the other one.
Wave App and Carrier Selection
03
Troubleshooting Wave App Pairing:
• If the Wave app is unable to connect to one of your devices, try force-closing the app.
• If force-closing the app doesn’t help, restart your phone and power cycle the GO X by
unplugging the power adapter.
