Wavecom Instruments Portable Appliance Testers Instruction Manual
17
Note 2:
Leakage test may be performed if for any reason a standard CLASS 1 or CLASS 2 is not possible.
Meter Mode®
Load Current: 0.0 to 10Amp
Voltage: 200 to 265VAC
Apparent Power: 0 to 2400VA
Power: 0 to 2400W
TnT Features
Meter Mode ®
(Not Available In Battery Mode)
Meter Mode Screen
How to Activate Meter Mode
Hold
F3
from main screen display for 2 seconds
Main Menu A
Volts Screen
Screen will change to show volts by default when socket is ( not powered )
Plug appliance into testers , test socket , Press F3 to go into power mode and will show
(Warning device will be powered
)
Press F3 again to continue and
(
power the device
)
.
If you continue the A-N LED on the tester will flash
green and device will power up. Otherwise press enter to exit.
Warning Screen
Amps Screen Watts Screen
Volts/Amps Screen
Press the enter key to stop the power mode and return to volts.
Pressing F3 key will start power mode again.
TnT stays in Meter Mode
regardless of power on/off until you exit
Pressing
Return key
will
exit
meter mode and return the main menu.
If the TnT is reset in meter mode it will return to meter mode when powered up again.
Meter Mode Uses
Meter Mode is a new and versatile function of the new Gen 4 tester that will allow you to display
Electrical Parameters
from a Power outlet source or from the appliance under test.
Typical Applications
Example.: Measuring the Power of a bar heater, or electric power drill check the ratings and compare them to that
on the compliance plate etc. Quick test of Power outlet Voltages in rooms or locations split from multiple circuits.
Meter Mode Features
– (Four Discrete Options)