MuB_xx_FBC-HC_EN_2011-08-16
Subject to technical modifications!
page 3
EN
5.2. E
LECTRICAL CONNECTION
All electrical connections must be performed by an authorised specialist in accordance with the local regulations
governing electrical installation work. The electrical cables must not come into contact with any hot components.
Usually cables for power supply, circulation pump, valve drive and flow temperature sensors are wired ex-works.
Just the outside temperature sensor as well as an optional temperature limiter and room thermostat has to be con-
nected on site (fig. 4).
Remove the cable jumper if an additional wired room thermostat is connected (fig. 4).
If the heating controller possesses RF thermostat interface please refer to the MuB both of the RF thermostat
and heating control.
Further information about electrical connections exists in the MuB of the heating control.
6. TECHNICAL DATA
Fittings and circulation pump
Max. ambient temperature:
0…+50 °C
1)
Max. fluid operating temperature: 0…+90 °C
1)
Max. operating pressure:
6 bar
Power supply:
230 VAC
Power consumption pump :
1)
1) Please refer also to technical leaflets of the pump
Control
CC-HC
Power supply:
230 VAC ±10 %, 50 Hz
Max. operating temperature:
0…+50 °C
Temperature precision:
0,1 °C
Regulation characteristics:
Non linear PID
Intelligent 3-point valve drive (finds the operating point)
Degree of protection:
IP 30
Protection class:
II
Output pump:
Relay 250 V, 5 A
Output valve drive (3-point):
2 Triacs 230 V, 2 A
Outside temperature sensor:
CTN 10 K
Ω
at 25 °C (class II – IP 55)
Water (flow) temperature sensor: CTN 10 K
Ω
at 25 °C (class I – IP 68;
except for connector
)
Software version:
Displayed when control is turned OFF. Cr_.__
HEAT output
(boiler…)
Fig.4
supply tempera-
ture sensor
Pump1
mixed circuit
outside tempera-
ture sensor (wired)
L
N
3-
Po
in
t-
val
ve dr
iv
e
ARA 600
NR230
L
N
N
L
power supply
230 V AC 50 Hz
L
N
COLD output
or pump2
return tempera-
ture sensor
(option)
Facility to connect an optional temperature limiter TB or
pump relay of a connecting box.
In that case remove the cable jumper placed at the screw connectors.
M
O
CO
M
C
1 brown
2 blue
3 white
brown
blue
black
O
CO
M
C
Close
Common
Open
C
CO
M
O
