wattstopper DT-355, Руководство по установке

Страница: 6 / 13

Using a 4-Inch Square
Junction Box
1. Pull the high voltage wires into
the J-Box through the conduit
knockout.
2. Run the wires through the CA-1
adapter then connect the high
voltage wires to the appropriate
terminals on the sensor.
3. Align the CA-1 and the sensor
with the J-Box so that the
mounting screw tabs on the box
match the mounting holes on the
sensor’s rear housing and the
CA-1.
4. Use two machine screws (included
with the sensor) to attach the sensor
to the mounting tabs on the J-Box.
5. Snap the front cover onto the sensor.
Using an Octagonal Junction Box
1. Pull the high voltage wires into the
J-Box through the conduit knockout.
2. Connect the high voltage wires to the
appropriate terminals on the sensor.
3. Align the sensor in the
J-Box so that the mounting
screw tabs on the box
match the key holes on the
sensor’s rear housing.
4. Use two machine screws
(included with the J-Box)
to attach the sensor to the
mounting tabs on the J-Box.
5. Snap the front cover onto
the sensor.
Call 800.879.8585 for Technical Support
Rear Housing
4" Square
Wiremold #V5752 box
Front Cover
Ceiling
Screws
CA-1 Adapter
Sensor Flange
MOUNTING THE SENSOR
4" Octagonal, 2.25" Deep
*
Junction Box
Ceiling
Sensor
Screws
Front
Cover
Mounting to an Octagonal Junction Box
Mounting to a 4” Square Wiremold V5752
box or 4” Square Junction Box with
Double-Gang Mudring
*
The Junction Box must be at
least 2.25” deep. If it is not, an
extension ring is required.