For 3/8” Configuration
PARTS LIST FOR ADAPT-A-VALVE (VERIFY CONTENTS PRIOR TO INSTALLATION)
ITEM
DESCRIPTION
A
Brass Adapter with black washer
B
Plastic Adapt-a-valve & Black Collet
C
White Rubber Washer
D
Brass Adapter with no washer
Step A -
Turn off the cold water supply to the faucet by turning the
angle stop valve completely off .
Step B -
Open cold water sink faucet to relieve pressure .
Step C -
Choosing the configuration that fits your plumbing, attach
the Adapt-A-Valve™ as illustrated in the four photos above .
Water supply line to the system must be from the cold water
supply line only. Hot water will severely damage your system.
Do not use Teflon tape with the Adapt-A-Valve™.
NOTICE
NOTICE
STEP 3
Adapt-A-Valve™ Installation
For 1/2” Configuration
D
B
LINE FROM
ANGLE STOP
VALVE
FAUCET
CONNECTION
FAUCET LINE
ANGLE STOP
VALVE
C
B
A
D
B
LINE FROM
ANGLE STOP
VALVE
FAUCET
CONNECTION
FAUCET LINE
ANGLE STOP
VALVE
C
B
A
STEP 4
Cold Water Connection
Step A –
Locate one of the white tubes
and insert one into the adapt-
a-valve making sure the tube
is pushed in all the way to the
tube stop
Step B –
Connect the other end of that
same white tube into the port
on the left-side of the filter
module . Near the filter labeled
“Sediment”
STEP 5
UF Drinking System Module Mounting
Step A –
Determine best location for the
UF Filter Module to be mounted
to allow for future system
maintenance . The parts bag has
2 self-tapping screws . Using an
electric drill with a Phillips bit,
screw them into the cabinet wall
6" apart and 16" from the bot-
tom of the cabinet .
5
