Watts BT-DRF, Быстрое руководство по установке

Страница: 10 / 72

10
1. Operating mode menu (active mode is framed).
2. Parameter number if “3” is displayed.
3. Installation Parameter menu.
4. Type of sensor used and temperature displayed.
Regulation => Internal or external ambient sensor.
Regulation => Floor sensor.
Regulation => Internal sensor with Floor limitation.
Regulation => View of the outside temperature
5.
Heating demand indication.
6. Low batteries indicator.
7. °C or °F unit indicator
8. Setting or measured temperature if “2” is displayed.
9. Key lock indicator
10. RF indicator.
2. First Installation
This section will guide you to set up your thermostat for the first time.
2.1 Batteries installation
- Open the two side’s covers and Insert the 2 AAA Alkaline supplied batteries (or remove the small protection sticker if the batteries are
already installed in the compartment)
- Close the two side’s covers.
- Now your thermostat will propose you to do the following adjustments
2.2 RF installation
- First of all to configure your thermostat with the receiver, you must put your receiver in « RF init ». mode. (please refer to the receiver
leaflet for this, only the RF receiver of the same range are compatibles)
- Now on the thermostat press and maintain the edition key
( ) during 10s, then the parameter «
ini
» must be display.
The thermostat will send now the radio configuration signal to the receiver.
- On the receiver check the good reception (generally showed by a green LED blinking). Once the configuration between the receiver
and the thermostat made, press on the escape key ( ) to come back to the main screen.
- Now you can check the RF distance, go to the room which must be regulated. Put your thermostat on the final position (On the wall or
table...), then put the thermostat in Comfort mode (setting temperature position 37°C). Close the door and go to the receiver to check if
the new status of the thermostat has received. (The heating is generally showed by a Red LED).
- Now return to the thermostat and switch off it. Check on the receiver again if it’s also switched off (The red LED must be turned off)
o
If the RF signals were received correctly, adjust your setting temperature as you want.
o
If the RF signals weren’t received correctly, check the installation (Receiver position, distance...)
* To make the installation easier it will be better to have the thermostat near to the receiver during the configuration mode. (A minimal
distance of > 1meter must be respected)
2.3 Start
The thermostat is now ready to works.
The default working mode will be Comfort