Watts Premier CT-1 Скачать руководство пользователя страница 5

Step C: 

Now that you have connected your CT-1 to the faucet you need to purge the air from 

the system.  Turn on the cold water. Pull out the diverter control button and water will run 

through the CT-1. (See figure C). 

Note: You may hear some noise as air is being purged 

from the CT-1 and the first few glasses of water through the unit may be dark color due 

to carbon fines.

  Run water through your unit until it is clear of carbon fines.

 

Your CT-1 is now ready to provide you with fresh, clean drinking water.  

FILTER CHANGE

Watts Premier recommends changing the filter 
element at least every 6 months or 1350 gallons 
(5100 liters). 

Use Watts Premier’s replacement cartridges 

only. 

Other filters may look the same, but only filters 

by  Watts  are  manfactured  to  fit    your  CT-1  filter 

unit in order to ensure proper reduction of water 
contaminants. 

Note:  There  will  be  water  in  the  CT-1  Filter 

Housing.  To prevent spillage, turn the CT-1 upside 

down  before  removing  Filter  Housing  from  the 

base.  See figure D.

Step 1: 

Remove  CT-1  filter  housing  from  base  by 

unscrewing it in a counterclockwise direction as 

shown in figure D.

Step 2: 

Slide out used Carbon Block and filter 

cartridge gaskets and discard.  

NOTE: Do not 

discard the CT-1 filter housing O-Ring.

Step 3: 

Clean inside the of the CT-1 filter housing with warm 

soapy water.  Rinse the CT-1 Housing with warm clean water 
to remove soap.

Step 4:

 

Lubricate filter housing O-Ring with a water-soluble 

lubricant (i.e. K-Y Jelly ® or Silicone lubricant) 

NOTE: Do 

not use Petroleum based lubricant (i.e. Vaseline 

®

).

 

 

Watts  Premier  Customer  Service  Department  (toll  free  within  the  United  States)  1-800-752-5582.  (Outside  the 

United States) 480-675-7995. M-F: 8:00AM – 5:00PM MST. Replacement filters are also available online at: 

www.

wattspremier.com

.

To Loosen

(Counterclockwise)

  To 

tighten 

  (Clockwise)

4

FIGURE D

Step 5: 

Seat O-Ring into filter housing grove.

Step 6:

 Slide new filter cartridge into filter housing and screw CT-Filter housing onto base.

Step 7:

 Repeat Step C (From initial instalation)  

For replacement filters or questions regarding installation or servicing, contact: 

Содержание CT-1










Отзывы: