background image

TI401

Page 2

Reprinted © April 2001 Powers, a Watts Industries Co.

3400 Oakton Street, Skokie, IL 60076 Phone: 800.669.5430 • 847.673.6700 • Fax: 847.673.9044

www.powerscontrols.com

5435 North Service Road, Burlington, Ontario, L7L 5H7 Canada • Phone: 888.208.8927 • Fax: 888.882.1979

A Watts Industries Co.

7. To install dial, remove plug button, peel backing off gas-

ket and attach gasket to inside dial top and sides allow-
ing approximately 1/8

(3.2mm) of gasket to protrude

past dial edge. Place dial over stem, and attach it to
mixer body with 2 screws provided. Dial handle must be
in horizontal position. Install plug button by snapping it
into handle with HOT–COLD indicator on right. NOTE: To
remove plug button, press indicator marking with thumb,
and snap out. Figure 5 shows relationship of ports.

8. When copper tubing is used flared fittings are recom-

mended. If flared fittings cannot be used, the balancing
chamber cartridge must be removed before soldering
near the Hydroguard body. Inlet checkstops with direct
with direct sweat connections are available in both
straight in and 90° angle configurations.

To remove the balancing chamber cartridge, remove the
four bonnet screws and lift off the bonnet. Pull out the
cartridge, with either pliers or cartridge puller. Before
replacing the cartridge, lubricate the side O-rings with a
small amount of grease or soap. Figure 6 shows body,
cartridge relationship.

9. Maximum Temperature Setting (Refer to figure 7). This

must be set on the job. Mixer will pas full HOT water.
Loosen screw B (do not remove). Rotate stem to get
desired maximum temperature. Move stop A until it
touches stop C. Tighten screw B. Special Case—with
high (over 140°F [60°C]) hot water. Remove screw B,
turn stop A over as shown by dashed lines (the word
“HOT” will face in) replace screw B. Reset stop A per
above. CAUTION: Adjustable stop A must be present
for proper operation.

Form TI401 0218

EDP# 6512236

Printed in U.S.A.

Отзывы: