Innovation Anode Retrofit Kit Instructions
Kit # 24429
TID-0128_0B
05/21/2015
AERCO International, Inc.
•
100 Oritani Dr.
•
Blauvelt, New York 10913
•
Phone: 800-526-0288
Page 2 of 6
1.
Introduction
This Technical Instruction Document (TID) provides instructions for installing the anode
assembly in Innovation water heaters in the field. This kit is delivered unassembled.
These instructions apply to all Innovation model water heaters.
Figure 1: Anode Assembly – Exploded View
2.
Tools Required
•
Assorted socket or open-end wrenches
3.
Preparing the Unit
To prepare the unit for the retrofit, perform the following:
Preparing the Unit for Retrofit
1.
Set the ON/OFF switch on the control panel to the
OFF
position. Disconnect AC power
from the unit by turning off power at the breaker.
WARNING! -
A high voltage of 120 VAC is used in Innovation water heaters. It is
REQUIRED that all power applied to the unit is removed before
performing the procedures described below. Use extreme care
when accessing circuits and electrical connections within the
equipment. Serious personal injury or death may occur if this
warning is not observed.
Various components may be hot. Care must be exercised to avoid
burns. AERCO suggests allowing the unit to cool to room
temperature before starting these instructions.
3/8-16 HEX CAP SCREW
(2 Each)
5/16-24 HEX CAP SCREW
(POSITIONING SCREW)
(1 Each)
1/4-20 HEX HEAD
SEAL BOLT
(4 Each)
ANODE
MOUNTING
BRACKET
(2 PARTS)
‘O’ RINGS
(2 Each)
