WattAge omega 636, Руководство по сборке

Страница: 5 / 20

5
KIT CONTENTS
We have organized the parts as they come out of the box for easier identification during assembly. Before you begin
assembly, group the parts like we list them. This will ensure that you have all of the parts before you begin assembly and
it will also help you become familiar with each part.
If you find a part missing or damaged please call our Customer Service Department at 1-714-962-0329 or send us an email
at service@globalhobby.net
AIRFRAME ASSEMBLIES
❑
{1} Molded Fiberglass Fuselage w/Motor & Prop
❑
{1} Right Wing Panel w/Aileron & Hinges
❑
{1} Left Wing Panel w/Aileron & Hinges
❑
{1} Horizontal Stabilizer w/Elevator & Hinges
CONTROL ASSEMBLIES
❑
{1} Nylon Inner Pushrod Tube
❑
{2} 2mm x 300mm Threaded Pushrod Wires
❑
{2} 2mm x 22mm Threaded Rods
❑
{2} Nylon Control Horns w/Backplates
❑
{4} 2mm x 12mm Machine Screws
❑
{4} Metal Clevises
MISCELLANEOUS ITEMS
❑
{2} Molded Plastic Servo Covers
❑
{8} 2mm x 6mm Wood Screws
❑
{4} Hardwood Servo Mounting Blocks
❑
{2} 3mm x 15mm Wood Screws
❑
{3} 40mm Velcro
®
Strips
❑
{1} Decal Sheet
WING ASSEMBLY
❑
{1} Aluminum Dihedral Brace
❑
{1} 2mm x 20mm Steel Pin
❑
{2} 3mm x 22mm Machine Screws
❑
{2} 3mm x 15mm Machine Screws
The covering material used on the Omega 636 is real iron-on heat shrink covering material, not cheap "shelf paper."
Because of this, it is possible with heat and humidity changes that the covering on your airplane may wrinkle or sag. This
trait is inherent in all types of heat shrink material. To remove the wrinkles you will need to purchase, or borrow from a
fellow modeler, a heat iron. If you need to purchase one, the Global Heat Sealing Iron # 360900 is recommended.
Follow these simple steps to remove the wrinkles:
❑
1) Plug in and turn on the sealing iron to the medium temperature setting. Allow the iron to heat up for approxi-
mately 5 - 7 minutes.
❑
2) After the iron has reached temperature, lightly apply the iron to the wrinkled section of the covering. Move the
iron slowly over the wrinkled section until the covering tightens and the wrinkles disappear. You will notice that the color
of the covering will darken when it is heated. When the covering cools back down, it will return to its normal color.
☛
If the color layer smears from any of the seams, the temperature of the iron is too hot. Turn the temperature dial down
and wait about 5 minutes for the iron to adjust to the lower temperature. You can remove any excess color streaks using
a paper towel soaked with a small quantity of Acetone.
A NOTE ABOUT COVERING
Wattage carries a complete line of replacement parts for your Omega 636. Listed on page # 17 are the replacement
parts that are available, along with their respective part numbers for easy ordering convenience. These replacement
parts can be ordered through your local dealer or directly from Wattage by calling 1-714-964-0329.