4 EDISON RAIL LAMP ASSEMBLY INSTRUCTIONS
Assembly of the Edison Rail Lamp is performed in the same manner for both Edison Junior and Edison Senior Rail systems: the
assembled lamp unit is mounted along the slot spanning the top of the rail. Rail modesty side panels (and water tray, Edison
Senior only) must be removed prior to mounting (
see below
), and reinstalled after mounting accessories (steps 7 - 9).
*
Please note Edison Senior is shown for most steps.
General Assembly Notes
Edison Senior: Panel Removal
Press down on the rail panels to lower them and reveal the fixing
screws on the opposite panel. Remove the #8-32x1/4” thread-
cutting screws (2x per panel) and set aside (a.). Remove the panels
by lifting from the bottom and pulling toward you. Set aside.
1.
a.
b.
Edison Senior: Water Tray Removal
Remove the water tray from the rail segment by
unscrewing the two M6-1x12mm screws on either end
of the segment. Set screws and washers aside.
2.
