Revision 1.8 / June 2016
5
Receiving Your MasoSine Pump
NOTE: Your MasoSine Pump has been inspected at the factory prior to shipment. All pumps are
shipped ready for service, i.e. completely assembled. The bearing housings have been supplied with
oil in them.
Inspect the shipping container and pump for evidence of damage during shipment.
If damage is found:
Note the extent of the damage before unpacking the pump.
Photograph the damage, as this is very helpful in making any claims against the carrier.
A pump lost or damaged during shipment is the responsibility of the carrier.
Watson-Marlow
MasoSine
will assist in tracing any lost shipments.
After uncrating your MasoSine Pump:
1. Check to be sure that the suction and discharge nozzles are covered. If the nozzles protective
covers have come loose or have been removed during shipment, it is important that the pump
interior be inspected. Any debris found in the pump should be removed.
2. Check the nameplate data against the shipping papers and against your purchase order to insure
that the proper pump has been provided and that the materials of construction match your
specifications.
3. If applicable, check to see that the proper drive has been supplied, particularly with regard to the
supply voltage required.
4. Inspect the suction and discharge nozzles to be certain that they are free of scratches and that
they are clean of any foreign substances. The gasket seating surfaces should be inspected
carefully, especially for vacuum and suction lift applications.
5. Liner/seal housing removal tools have been provided to assist you with maintenance of the
MasoSine Pump. These tools (there should be two) can be found in the crating.
If there are any questions regarding receiving your pump, please contact
Watson-Marlow MasoSine
at +49 (0)7062 9560-0
Warranty and Liability
Basically our “General sales and delivery conditions” apply. These are available to the operator at the
latest since conclusion of the contract.
Warranty and liability claims for personal and material damage are excluded if they are attributable to
one or several of the following causes:
- Use of the machine not as intended
- Incorrect installation, operation and maintenance of the machine
- Operating the machine with defective safety devices or not correctly attached or not functioning
safety and protective devices
- Non-compliance with the instructions in the operating instructions regarding
transport,
storage,
installation,
start-up,
operation, maintenance and setting of the machine.
- Unauthorized constructional changes to the machine
- Insufficient monitoring of machine parts subject to wear
- Incorrectly performed repairs
- Cases of catastrophe due to effect of foreign bodies and acts of God.
