Watson-Marlow 520DuN IP66/NEMA 4X User Manual
41
18.3 Display
The pump can display three default screens in manual mode: revolutions per
minute, flowrate in a choice of units, or both.
In the first screen of the Setup menu select
Display
using the
UP
and
DOWN
keys. Press
ENTER
to confirm your choice.
The pump displays a screen allowing you to choose the format of the manual
mode main screen. Use the
UP
and
DOWN
keys to choose and press
ENTER
to confirm your decision.
If you choose
Flowrate
and you have not calibrated the pump since switching
it on, a warning screen is displayed for 4 seconds. The warning does not appear
if the display screen formats are cycled again, unless the pump has been
switched off in the mean time.
The pump redisplays the first screen of the Setup menu.
When the pump next runs, the manual mode main screen will display pump
activity in rpm, flowrate (in the units you chose - see 18.8
Flow units
) or both,
according to your choice, plus a run time figure. Examples are shown here.
Alternatively ...
In the manual mode main screen, repeatedly press
ENTER
to cycle the display
between rpm, flowrate (in the units you chose - see 18.8
Flow units
) or com-
bined, according to your choice. This cycle operates if the pump is running and
if it is stopped. While the pump is running, you can cycle the display in the
same way by repeatedly pressing
START
. In both cases, if you have not cali-
brated the pump since switching it on, a warning screen is displayed for 4 sec-
onds before the flowrate screen appears. The warning does not appear if the
display screen formats are cycled again, unless the pump has been switched off
in the mean time.
The pump redisplays the first screen of the Setup menu.
