Watson Marlow Pumps 630 Series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 39 / 131

15 Switching the pump on in subsequent power cycles
Subsequent power-up sequences will jump from the start-up screen to the home screen.
l
The pump runs a power-on test to confirm proper functioning of the memory and hardware. If a
fault is found, an error code is displayed.
l
The pump displays the start-up screen with the Watson-Marlow Pumps logo for three seconds
followed by the home screen
l
Start-up defaults are those in place when the pump was switched off last
Check that the pump is set to operate as you require it. The pump is now ready to operate.
All operating parameters may be changed by means of key-presses (see
"Pump operation " on
page 17
).
Power interruption
This pump has an auto restart feature (which only affects manual mode) which, when active, will restore
the pump to the operating state it was in when power was lost.
Stop/start power cycles
Do not power up/power down the pump more than 12 times in 24 hours, whether manually or by
means of the auto-restart facility (which only affects manual mode). We recommend remote control
where a high frequency of power cycles is required.
m-630en-en-01 39