PRODUCT SUPPORT | 800.927.2120 | WATERWORKS.COM
PAGE 2 OF 3 | UPDATED ON 5.05.2020
STYLE No. RHWS01
Rhea Marble Two Leg Single Washstand
with Top and Sink 42” x 24” x 35”
INSTALLATION GUIDELINES
6. Carefully install the APRON SLAB into the notches
on each LEG, using the screws and washers
provided, fasten the FRAME to the APRON SLAB.
5. Move BASE back into position and fasten the
FRAME with the SCREWS and WASHERS provided.
4. Dry fit the BASE to the desired position against the wall
ensuring the LEGS are level and mark the FRAME’s hole
locations. Remove the BASE. Drill pilot holes in the wall
in the marked locations. Install plastic WALL ANCHORS
[not supplied] if no stud or blocking is present.
3. Use one SCREW and COLLAR to fasten the BAR to
one LEG. Cover the COLLAR with the HEX CAP and
secure it with the SET SCREW. Repeat on the other
LEG. Install the second BAR following the same
process. This completes the washstand BASE.
2. Fasten the FRAME to the pre-installed marble
anchors of the LEFT LEG and RIGHT LEG using the
WASHERS & SCREWS supplied.
1. Place the LEFT LEG & RIGHT LEG on the protective
work surface with the MARBLE ANCHORS facing
upwards and place the FRAME in between the
LEGS.
