To stack the modules:
1.
Place the rear feet of the module that you are adding atop the previously added module in
the system stack, and slide it backward until its rear alignment pin rests in the rear
alignment slot on the previously added module.
Figure B–1: Aligning pins with slots
Alignment pins
Alignment slots
2.
Lower the front of the module that you are adding so that its front alignment pin rests in the
front alignment slot on the previously added module.
3.
Repeat steps 1 and 2 for the remaining system modules.
B.6 Stacking system modules without interlocking features
This procedure applies to system modules that are not equipped with interlocking features. Most
modules will, however, have interlocking features.
Warning:
To avoid spinal and muscular injury, do not attempt to lift a system module
without assistance.
Warning:
To avoid crushing your fingers beneath or between modules, use extreme
care when installing a module in the system stack.
To stack the modules:
1.
Align the front and rear feet of the module that you are adding with the corresponding
indents in the top of the chassis of the previously added module in the system stack.
April 4, 2018, 715005704 Rev. A
Page 78
