ST E P 1
Remove the rails (A) from their boxes, noting the label on the box specifying the
Left and Right rails. Stand the rails on their feet, and note the location of the black
plastic strips the seat rolls upon. Remove the rear end pad assembly (B) from
the tank box. Carefully align the brackets of the rear end pad assembly with the
interior (tubular) section of the rails.
Note: The rear end pad should be installed on the end of each rail that is closest to the
black plastic strips the seat rolls upon.
ST E P 2
Using the provided ratchet (K), secure the rear end pad assembly to the rails
using four button head cap screws (G) and four washers (H).
ST E P 3
Remove the seat (C) from the tank box and place it on/between the rails.
The indented portion of the seat cushion must face towards the rear end pad
assembly as shown. The larger, vertically-mounted wheels (load wheels) should
sit on the plastic extrusions on top of each rail. The smaller horizontal wheels
below the seat (guide wheels) should sit between the rails, underneath the lips of
the plastic extrusions.
Note: It may be necessary to separate / tilt the rails slightly to allow the guide wheels to fit
between the rails and under the lip of the extrusions.
ST E P 4
Remove the tank assembly (E) from the tank box. Carefully slide the tank
assembly onto the rails as shown.
Note: The metal brackets protruding from the front end pad (on tank assembly) fit inside the
tubular section of the rails in the same way that the rear end pad assembly fit into the rails.
ST E P 5
Using the provided ratchet (K), secure the front end pad of the tank assembly to
the rails using four button head cap screws (G) and four washers (H).
1 1 .
1 2 .
A S S E M B L I N G T H E R O W E R
B
A
K
G
H
C
E
K
G
H
ST E P 6
Remove the top cover (F) from the tank box. Starting just behind the monitor,
position the cover at an angle (as shown). Slide it downward and horizontally
toward the front of the rower so that it covers the clutch and recoil mechanism
area. Gently fit the front edge of the cover into the supporting / protective shims.
F
