Waterpik WF-20 Series, Инструкция по эксплуатации, Страница: 7 / 28

7
E
N
G
LIS
H
Adjusting the Pressure Setting
You can adjust the pressure setting on your Water Flosser by simply sliding the pressure/power switch on the handle.
Slide power switch up 1 click for Low (l) pressure and 2 clicks for High (ll) pressure.
Start with the lowest setting and increase to your liking.
Recommended Technique
Lean low over sink and place tip in mouth. Aim the tip toward gumline, and turn the unit ON (I).
For best results, start with the back teeth and work toward the front teeth. Glide tip along gumline and pause briefly between teeth.
Continue until you have cleaned the inside and outside of both the upper and lower teeth.
Direct the jet stream at a 90-degree angle to your gumline.
Slightly close lips to avoid splashing but allow water to flow freely from
mouth into the sink. Keep unit upright during use for best results.
When Finished
Turn the unit OFF (O). Empty any liquid left in the reservoir.
If desired, the reservoir may be removed from the power handle by simply pulling down on the reservoir to remove.
High
Low
Off
Remove