Waterous ECLIPSE CAFSystem 2.0, Инструкции по установке, эксплуатации и обслуживанию

Страница: 39 / 44

Safety Introduction Product Overview Installation Operation Maintenance Troubleshooting Warranty
39 | 44
Replacing the Oil Filter
1. Relieve airline pressure before servicing. Refer to: "Relieving
Airline Pressure" on page 37 .
2. Locate and remove the used oil filter ( Figure 20) .
3
2
1
1. Oil filter 2. Radiator fan 3. Radiator
Figure 20
3. Prepare the replacement filter by applying sump oil to the surface
of the rubber gasket.
4. Install the replacement filter.
5. Operate the air compressor to circulate oil into the filter.
6. Check the oil level and add oil if necessary refer to: "Adding Sump
Oil" on page 38 .
7. Cleanup any spilled oil.
Servicing the Compressor/Pump Drive Belt
1. Locate and loosen the jam nut on the slide block bolt ( Figure 21 ).
2
3
1
4
6
7
5
1. Tension hardware
2. Compressor belt
3. Belt tension plate
4. Pivot hardware
5. Pump belt
6. Slide block bolt
7. Jam nut
Figure 21
2. Turn the slide block bolt to loosen the belt tension enough to
remove the pump belt.
3. Loosen the hardware that secures the compressor belt tension
plate ( Figure 21 ).
4. Loosen the tension and remove the belt.
5. Install the replacement belt.
6. Set the belt tension to 70-80 lb (32-36 kg).
7. Tighten the hardware to secure the compressor belt tension plate.