F-1031, Section 3046
Page 4 of 10
Pump Mounting - CPK-5 Series
Figure 1 shows the mounting areas on a CPK-5 pump. To
mount the pump/transmission to the vehicle chassis, construct
a bracket that will span the frame rails of the vehicle and attach
to the transmission mounting holes (several locations are pro-
vided).
NOTE: Before installation, make sure your pump has
the right rotation as compared to the driveshaft rota-
tion (see dimensional drawings for correct rotation
configurations).
Position the pump/transmission within the vehicle frame
rails and secure the brackets (not supplied) to the vehicle
frame.
Support the pump by using the mounting plate on the pump
as shown in Figure 1.
NOTE: Tighten the mounting screws to standard torque
specifications.
Finally, provide adequate support for any intake and dis-
charge piping assemblies.
Figure 1. CPK-5 Mounting Diagram
(6) Mounting Holes
(7/16-14 UNC-2B x .625 in. deep)
(2) Mounting Holes
(7/16-14 UNC-2B x .625 in. deep)
Pump Mounting Plate
