INSTALLATION FOR
WALL MOUNT AUTOMATIC FAUCET
Rev. 2/20
P a g e
|
5
button 1 time for each level to be changed. When desired level is
reached, wait for series of flashes from Red LED to confirm level.
Note: Level should be adjusted 1 step at a time and tested.
Faucet functions
intermittently
Calibration not
complete
Follow Step 20 above. It may take up to one week of regular use for
sensor to fully learn environment.
Sensitivity too low
Adjust sensitivity. Press and hold the White Button until Red LED is
permanently lit, about 10 seconds. When finger is removed, Red
LED will light in a series of flashes to indicate sensitivity level. 1
flash is the lowest and 5 flashes is the highest. Press the white
button 1 time for each level to be changed. When desired level is
reached, wait for series of flashes from Red LED to confirm level.
Note: Level should be adjusted 1 step at a time and tested.
Bad connection
Check installation. Make sure sensor wire and solenoid wire are not
touching each other or any metal. Make sure sink and counter are
not metallic. Remove and replace battery, wait for Red LED to turn
off and follow Step 20 above.
Faucet does not
turn off
Sensitivity too high
Adjust sensitivity. Press and hold the White Button until Red LED is
permanently lit, about 10 seconds. When finger is removed, Red
LED will light in a series of flashes to indicate sensitivity level. 1
flash is the lowest and 5 flashes is the highest. Press the white
button 1 time for each level to be changed. When desired level is
reached, wait for series of flashes from Red LED to confirm level.
Note: Level should be adjusted 1 step at a time and tested.
Bad connection
Check installation. Make sure sensor wire and solenoid wire are not
touching each other or any metal. Make sure sink and counter are
not metallic. Remove and replace battery, wait for Red LED to turn
off and follow Step 20 above.
For technical support, please call 718-257-2800