3.
Completely remove the plastic internal reservoir from the
WL270
.
3a. Remove and discard the
clear silicon float
protector from the
electronic float.
3b. Loosen the water supply
line fitting from the
mechanical float.
3c. Disconnect the white
plastic electrical
connectors attached
externally to the
electronic float.
3d. Pull the silicon ¼” vent
line loose from the hot
tank where it attaches
to the plastic reservoir.
4.
Scrub the internal surfaces with soapy water using an unused sponge or paper towels.
5.
Rinse well with clean water.
6.
While avoiding touching the wetted surfaces of the reservoir with your hands, reinstall the
reservoir into the
WL270
, reversing the removal steps you performed prior.
Sanitizing the machine
Materials Needed:
•
Personal Protective Equipment. Rubber or Nitrile Safety Gloves and Protective Eyewear
•
Phillips Screwdriver
•
Sanitizer - Household Bleach (5.25% Sodium Hypochlorite) or Citric Acid Based Cleaner
•
Unused sponges or paper towels
1.
Install the hose adaptor fitting that is packed in the accessories bag found in the drip tray onto
the water inlet fitting on the back of the machine.
CAUTION!
DO NOT OVERTIGHTEN
2.
Install the metal stand-off plate from the accessories bag and install over the water inlet.
Connect a section of the ¼” plastic tubing from the water supply line into the hose adaptor fitting
at the back of the unit.
CAUTION!
DO NOT TURN ON THE WATER YET
3d
3a
3c
3b
WL270
Operating, Installation, and Service Manual Page 11 - Revision: 4-7-2015
