WATERKOTTE EcoTouch Ai1 Geo, Планирование и установка

Страница: 23 / 60

Installation of heat pump and tank
12.11.2015
23 / 60
Z21826
Copyright

2013 by: WATERKOTTE GmbH. Subject to changes
7.2.2 Temperature sensor
The provided temperature sensor is already inside the immersion sleeve.
7.2.3 Removing of the housing
Front and side panel are removable for transport and assembly cases.
Order of removing : At first the front panel, than the two side panels.
A removal tool is delivered with the heat pump. Use this tool to remove the panels
and avoid damage.
Procedure:

Keep distance between the dismantling tools and the sheet edge to keep
the retaining pin undamaged (see figure).

The dismantling tool should be exact between front and side panel with
moderate force.
Notice: The Display in the front connected with two connections (see at the pic-
ture). Separate the connection on the backside, after you have removed the front
panel.
Procedure:
Pos.1 –Raise the switch out of the suspension clamp with the screwdriver.
Pos.2 – The plug of the bus cable has a retaining tab . Press this up and unplug the
cable.