•
Waterproof adhesive (epoxy, silicone or fibre glass adhesive) to mount the block.
Pump Mounting Instructions
:
Warning
: remove any polystyrene or foam blocks covering the pump around for shipping
purposes.
•
Step 1
: make sure you mount the pump facing down or aside on its feet make sure it is
holding firmly as to avoid too much vibration that will affect your seals and bearings.
•
Step 2
: now insert your hose inlet/outlet and use hose clamps to secure the pipes.as is the
pump has high pressure it’s advisable to use h
ose pipes or high pressure flexi hoses.
•
Step 3
: now you can link your inlet pipe to the water source and outlet to the supply, you
must always watch for the inlet/outlet arrow when installing this type of pump.
•
Step 4
: make sure your pump is not more than 2m high or away from water source when
self-priming.
•
Step 5
: make sure you pump is covered or protected from water or rains never submerge
the pump.
•
You can adjust your pressure by opening the front cover screw on the pressure switch,
inside there is another screw by turning it clockwise you can adjust the start and stop
pressure
.
Pump mounting:
•
Operation
:
1.
Connect your -+ terminals accordingly to your battery positive and negative poles.
2.
Make sure you have right size fuse on your positive pole.
3.
Connect your pump to the control switch, depending on what operation you are using the
pump for;
