INSTALLATION
Receive and Check Pump
Check the pump packaging for damage. Check for shipping damage such as dented, cracked
or bent parts. If damage is detected contact the shipper or distributor from which the pump
was purchased.
Lifting and Handling
a) Hydrostar Pump Procedure
This pump requires two people to move and position the pump into place.
b) Hydrosteel Pump Procedure
The eye bolt built into the motor body is not designed to support the combined weight of the
motor and pump body. DO NOT attempt to lift the pump by attaching a clip to this eye bolt.
Use a minimum of two chains or straps to support the entire motor and pump. The crane or
hoist used, as well as each individual chain or strap, must have a weight-bearing capacity in
excess of the combined weight of the motor and pump.
c) Cast Iron Pump Procedure
The eye bolt built into the motor body is not designed to support the combined weight of the
motor and pump body. DO NOT attempt to lift the pump by attaching a clip to the eye bolt.
Use a minimum of two (preferably three) chains or straps to support the entire motor and
pump. The crane or hoist used, as well as each individual chain or strap, must have a weight-
bearing capacity in excess of the combined weight of the motor and pump.
I pg 05
WARNING
!
Crushing Hazard. NEVER walk or reach under a suspended pump.
For models where the wet end is made out of a composite material instead of cast iron – DO
NOT place any straps under the wet end for lifting – this will cause the wet end to crack. In
these scenarios – place the lifting strap under the pump housing.
Lifting Procedure
i) Raise the pump slowly to ensure that the chains or straps will not slip when
under tension.
ii) Check that the pump is properly balanced when it is raised. If it is not, release the
tension on the chains or straps and readjust their position.
Pump Location
a) The pump should be located in a position that enables easy access for periodic servicing.
Leave the area above the pump lid clear for removal of the basket for cleaning.
b) The pump and other circulation equipment must be located a minimum of 1.5m (5ft) from
the water.
c) The pump elevation should not be more than a few feet above the water level of the pool;
it is recommended that the pump be located within 0.30m (1ft) of the water level.
d) If the pump is installed below water level, shut off valves (butterfly valve for 80mm or
larger) should be installed on both the suction and discharge piping to prevent back flow
of pool water during routine servicing of the pump and other circulation equipment.
e) Place the pump on a solid foundation that will not vibrate. It is suggested that the pump
be bolted down to reduce noise from vibration.
f)
The pump foundation must have adequate drainage to prevent the motor from being flooded.
g) Protect the pump from the sun and rain.
h) Install the pump in a well-ventilated area – ensure there is enough clearance around the
motor and fan cowl.
If the pump is installed under cover, provide adequate ventilation and lighting.
Attach harnesses at
these points. Ensure
that the pump is kept
level when lifting.
Do not use this
eye bolt to lift
the pump.
Waterco Commercial Pump