OPERATION OF YOUR POOL HEATER
Operation of Multi-Function Electronic Control Panel
The display of the control panel is factory set to show pool water temperature in degrees
FAHRENHEIT. See “To select temperature in °C or °F” section in the general user handbook.
To start-up the unit
When the unit is turned
“ON”
or after a power shut down, the panel lights up to indicat
“OFF”
or the temperature of the pool water circulating inside the heater. Program the desired pool
water temperature.
Once programmed, the fan starts and the compressor will start after a 3 to 5 minute delay.
NOTE:
The fan motor and the compressor may start at the same time when the unit has been
stopped for a long period.
To stop the unit
The unit can be stopped by switching off the electrical power supply or by programming the
desired water temperature below actual pool water temperature. The unit will be
“OFF”
if the
temperature set point is below 15°C. The display indicates
“OFF”
.
To raise or lower desired water temperature
(Pool or Spa mode)
Push the
SET
key until you see
POL
or
SPA
. Press the
UP
or
DOWN
arrow only once and the
programmed temperature is displayed. Press the
UP
or
DOWN
arrow to increase or decrease
the temperature setting by one degree at a time. Once the control has been programmed
to the desired pool water temperature, the programmed temperature will be displayed
for approximately 5 seconds, then the digital display will return to the actual pool water
temperature.
• To toggle between
function
• Actual temperature and
setting display
• Pool Mode
• Compressor running
• Spa Mode
• To lower desired temperature
or to change settings
• To raise desired temperature
or to change settings
Touch Pad Description