WaterClinic LAL-267, Руководство пользователя, Страница: 16 / 48

ENG 14
Flushing the RO Membrane
As water passes through the RO membrane, impurities and bacteria are
retained on the membrane surface, so you should regularly flush
the machine to ensure that the RO membrane performance is optimized.
Each time the machine is turned on, it will automatically flush
the RO membrane for 18 seconds.
Filter Replacement Intervals
• The filter replacement cycles for the various filters used in this purifier is
derived from statistical indicators on the estimates of average tap water
usage. If there are considerable discrepancies between the users supply
water quality, utilization rates and average indicators, there will be more
obvious differences between the filters actual replacement intervals
and estimated life-cycles and users may experience premature filter
clogging, premature failure, etc. If this occurs, filter replacement
intervals should be based on actual usage conditions. You should also
contact your local after-sales service department immediately to inform
them of the situation.
• This machine’s estimated filter replacement cycle is based on average
household water consumption and is suitable only for residential use,
do not install this machine in places that require large volumes of water.
If the water volume requirements are large, our company offers
appropriate equipment tailored for commercial applications.
• According to economic statistics on municipal tap water, a three person
family on average uses 10L of water a day. According to the water
volume and inlet water quality conditions, approximate filtering
volumes are as follows (the following data is for reference only):
Maintenance and Repair
• The major components of this product are manufactured using plastic.
When using the water purifier, always observe the integrity
of the equipment in order to ensure safe operation.
• The package of the reverse osmosis membrane contains a small amount
of protective solution in order to prevent microbiological contamination
of membrane components during storage and transportation. The post
activated carbon filter may emit activated carbon powder the first time
it is used. So do not open the water storage tank during the first hour
when the water purifier is put into operation. It is recommended that
the water produced during this period is disposed of. Otherwise,
the taste of the pure water may be unusual.
• When you first operate the water purifier, the pure water TDS value may
be a little high. After operating for some time, the TDS value of the pure
water produced will gradually decrease until it is stable.
• When you are using the water purifier, the inlet water ball valve should
be opened and the pure water faucet needs to be turned on. When
you are not using water turn off the water faucet, the high pressure
switch will automatically cut off the water supply.
• When you first use the storage tank it is recommended that you discard
the first tank of water; otherwise it may result in abnormal tasting pure
water.
•
It is recommended that you use the machine at least twice a week
to prevent microbiological contamination caused by the equipment lying
idle for an extended period of time, which in turn might cause odors
in the water.
• In these “operation methods”, “operation” refers to the power supply
being connected and/or the inlet water ball valve being open
so the water purifier is in an operational state.
Operation Methods
WATER VOLuME (TONS)
7.5
7.5
10
50 - 75 - 80
6
PROgRESSION
First: 10/20-inch 5-micron PP filter
Second: 10/20-inch 85C GAC filter
Third: 10/20-inch Block carbon cartridge
Forth: Reverse Osmosis Membrane
Fifth: Post-activated carbon filter