WaterCare TC1-TW, Руководство пользователя

Страница: 3 / 36

PREINSTALLATION INSTRUCTIONS FOR DEALERS:
3
The manufacturer has preset the water treatment unit’s sequence of cycles, cycle times, salt dose, exchange capacity and
salt dose refill time .
The dealer
should read this page and guide the installer regarding hardness, day override, time of regeneration,
service alarm and buzzer alarm settings before installation.
For the installer , the following must be used:
• Program Installer Settings: Time of Day and Hardness (manufacturer has set system to Immediate Regeneration;
see Operating Displays and Instructions for more details), Service Alarms (preset to “OFF”) and Buzzer Alarm
(preset to start at 6 a .m . and end at 10 p .m .)
• Read Normal Operating Displays
• Set Time of Day
• Read Power Loss & Error Display
• Be sure system and installation are in compliance with all state and local laws and regulations .
For the homeowner , please read Programming Procedures and Operating Displays and Instructions .
During operation, the normal user display is time of day and gallons per minute .
Flow Rate, Vacation Mode, Capacity Remaining and Days to a Regeneration are optional displays but are not normally
used . (Vacation Mode is used only when there will be no water usage for an extended period of time . Once 50 gallons
of water is used, the unit will automatically regenerate that night and resume normal operation .) Each of these can be
viewed by pressing
next
to scroll through them . When stepping through any programming, if no buttons are pressed
within 5 minutes, the display returns to a normal user display . Any changes made prior to the 5 minute time out are
incorporated . To quickly exit any Programming, Installer Settings, etc ., press
set clock
. Any changes made prior to the
exit are incorporated .