WaterBoss 97WB-IF, Установка и обслуживание

Страница: 6 / 32

3
Checklist Before Installation
1. Water Pressure - Not less than 30 psi constant for WaterBoss ® filters.
2. WaterBoss
®
97WB-AF adjusts low pH water to a neutral, non-corrosive state.
WaterBoss
®
97WB-CF reduces chlorine taste and odor.
WaterBoss
®
97WB-IF reduces iron, hydrogen sulfide and iron bacteria.
3. Water Supply Flow Rate - 5 gallons per minute is recommended as minimum.
4. Drain - Drain appliance to floor drain or washer drain. To prevent back-siphoning,
the installer must provide an adequate air gap or a siphon break. See figure 1.
5. Electricity - The transformer supplied is a standard 120 volt, 60 cycle A.C. for USA or
220 volt, 50 cycle A.C. for outside the USA. See figure 8.
6. Water Quality - If the water supply contains sulfur, bacteria, iron bacteria, tannins,
algae, oil, acid or other unusual substances, then unless the appliance is represented as
being capable of treating these contaminants in the specifications, other special
treatment of the water supply must be used to remove these contaminants before they
enter this product.
If you have any questions call our HelpLine!
When calling the HelpLine, please have this guide and the serial number available.
From 8 am to 5 pm EST, call 1-800-437-8993. Your serial number may be found on top
of your valve assembly (See figures 2-3.)