DO’S AND DONT’S
•
DO ALWAYS
check your state and local regulations regarding plumbing and electrical
connections and placement of the system before installation.
•
DO
install the Reionator Pro® system into the existing cold water supply line before the
water heater and before any cold water outlet that requires treatment.
•
DO
bypass your system in the event of a water or plumbing related emergency.
•
DO
decrease your usage of all cleaning products such as: soap, detergents, shampoo, etc.
Most homes can reduce their use of these products by 50% to 75% because they work
more efficiently in Reionator Pro® conditioned water.
•
DO
inspect the brine tank monthly.
•
DO
initiate a regeneration manually if high water usage is expected due to guests, heavy
laundry or other reasons.
•
DO
contact your WaterTech Dealer if you have any questions about the operation of your
system or water quality issues.
•
DO
enjoy all the benefits of your Reionator Pro® conditioned water!
•
DO NOT
hang or stack items on your equipment. This may cause an equipment imbalance
or put a strain on plumbing and electrical connections.
•
DO NOT
disconnect or remove any part of the plumbing or electrical cord.
•
DO NOT
attempt to reprogram your system (except for the time clock setting). Your
system has been factory or field programmed specifically for your application.
•
DO NOT
overfill the brine tank with salt. Approximately 6 inches below the rim is the
maximum recommended fill.
•
DO NOT
allow your Reionator Pro® and attached plumbing to be exposed to extreme
temperatures (below 40° F or above 110° F).
•
DO NOT
use with water that is microbiologically unsafe or of unknown quality without
adequate disinfection before or after the system.
2
