Water Right FF-948-M, Руководство по установке, Страница: 8 / 20

13. Place bypass valve in "bypass" position.
Figure 5
14.
Fully open the house main water shutoff valve. Observe a steady flow from both faucets opened earlier.
15. Slowly, turn bypass valve back in the "service" position. Keep soft water faucets open.
16. After about 3 minutes, open a HOT water faucet for one (1) minute, or until all air is expelled, then close.
NOTE: If water appears cloudy or has salty taste, allow to run for several more minutes, or until clear.
17. Close all water faucets.
18. Check plumbing work for leaks and fix immediately if any are found.
19. Remove the cover and add water into the tank. Although the material used in the manufacturing of this water
softener will not contaminate your water supply, the softener could become contaminated during shipment and
installation. The media inside the resin tank may also have become disturbed during shipping. The following
procedure will help re-position the media, sanitize, flush and condition your water softener:
a) Add 1-1/2 ounces of common household bleach to the water in the cabinet (brine tank).
b) Following the directions in the Control Service Manual, manually advance the softener through each step of
regeneration pausing for 10 minutes in each cycle except the Fill cycle (see step c.).
c) Repeat step 19a and 19c after any service has been performed on your water softener.
20. Turn ON the gas or electric supply to the water heater.
21. Remove the cabinet cover and add salt into the tank. Use only nugget, pellet, block or coarse solar salt with a
purity of 99.5% or higher. DO NOT use rock, granulated, and ice cream-making salts. Keep the brine tank cover
on unless servicing or refilling with salt.
22. Connect electrical power by plugging into a (120 volt) outlet.
23. With the valve In Service , manually initiate regeneration as the final installation step. This regeneration will:
a) Fill the brine tank with the appropriate amount of water for the 1st regeneration
b) Complete the final flushing and conditioning of the water softener.
c)
Re-classify the resin bed if the bed was disturbed during shipping.