26
WATERMAZE SERIES
OPERATOR’S MANUAL
WB • 8.913-984.0-L
WATER MAZE
CYCLE TIMER
QUICK REPROGRAMMING
INSTRUCTIONS
Function Settings
Reset Button. Push to restart after power
outage.
Scroll Button. Push to select the different pro-
gramming modes. Also saves program values.
Vertical Scroll changes programming values.
Horizontal Scroll for multiple values. Also
changes programming values.
Programming
1. Pull face plate of timer out of its holder in electrical
box with your fingers. Along the left side (wall) of
the circuit board, the blue disable jumper needs to
be pulled upward and moved back one pin position.
This will allow for reprogramming. Slide timer back
into its holder.
2. Press button until LED screen in green shows
(
PRS #02
). Push the
▲
or button until the new run
time appears in green Then press the button
once to save the setting for preset 1.
3. Press button once more. The LED screen will
show
(
PRS #02
). Push the
▲
or until the value in green
is the same value as preset 1. Press button to
save setting for preset 2.
4. Remove timer once again from its holder in the elec-
trical box. Change the blue disable jumper back to
the most forward pin position. Slide the timer back
into its holder in the electrical box.
▲
Program Disable Jumper Settings
Program Disable Plug Jumper
The program disable plug jumper is used to enable and
disable front panel programming. The plug jumper is
located on the CPU board.
User Input and Program Disable Jumper Locations
User Input and Program
Disable Jumper Locations
FIGURE 10
Содержание WB Series
Страница 58: ...Form 8 913 984 0 L Printed in U S A...