11
OPERATING DISPLAYS AND MAINTENANCE:
The air sulfur and air iron filter systems look and function much like any backwashing whole house filter; however, unlike these
conventional filters, they use air as a regenerant. This atmospheric air (containing oxygen) helps convert iron or hydrogen
sulfide into particles. These filters capture the particles of iron or hydrogen sulfide gas within the filter media. Your dealer has
recommended the proper media depending on your local water conditions. In some cases where an acidic water condition
(low pH) is present, the media may need to be periodically replenished if using this filter to raise the pH to an acceptable level.
Consult dealer for this service. The system is prefactory set to regenerate every (3) three days at midnight. The frequency and
start time of backwash/regeneration is adjustable to meet local operating conditions and contaminant levels. Total backwash
and recharge time is normally one half hour.
1.
GENERAL OPERATION:
When the system is operating, one of five displays may be shown and will alternate with the installing
dealer’s name and phone number for future service. Pressing
NEXT
will alternate between the displays.
1.
CURRENT TIME OF DAY
and
GPM
2.
FLOW RATE
which is the current treated water flow rate through the system in Gallons Per Minute
3.
VACATION MODE
allows the system to be “shut down” when there will be no water usage for an extended period
of time
4. CAPACITY REMAINING
which is the gallons that will be treated before the system signals a regeneration cycle
5.
DAYS TO A REGEN
is the number of days left before the system goes through a regeneration cycle, based on the days
override value
6.
DEALER NAME AND PHONE NUMBER
is the dealer information to call when service is needed (this screen will only
appear if set by dealer)
The user can scroll between the displays as desired.
If the system has called for a regeneration that will occur at the preset time of regeneration, the words “REGEN
TODAY” will appear on the display.
If a water meter is installed, “GPM” flashes on the display when water is being treated, indicating gallons per
minute going through the system.
2.
VACATION MODE:
This feature may be used to “shut down” the system while on vacation. The manufacturer has
factory set “OFF” as the default. Turn feature “OFF” or “ON” using the
+
or
—
buttons. When turned “ON”, the
unit will not regenerate while there is no water usage. Once water usage is observed (minimum of 50 gallons), the
unit will automatically regenerate that night and resume normal operation.
CAUTION:
Depending on the severity of water conditions and the length of no water
usage, it may not be recommended to use this feature. Please contact
dealer or manufacturer for more information.
3.
REGENERATION MODE:
Typically a system is set to regenerate at a time of no
water usage. If there is a demand for water when the system is regenerating, untreated
water will be delivered. When the system begins to regenerate, the display will include
information about the step of the regeneration process and the time remaining for that
step to be completed. The system runs through the steps automatically and will reset
itself to provide treated water when the regeneration has been completed.
REGENERATION MODE
1
TIME OF DAY
MON
GPM
2:40
8
PM
2
FLOW RATE
GPM
8.0
5
ON VACATION
NO
6
PHONE NUMBER
DEALER NA
3
CAPACITY REMAINING
GPM
GAL
1600
8
4
DAYS TO A REGEN
GPM
3
8