24
・
Flickerless mode
Change the exposure mode to “1” or “2” and you can change the Flickerless mode of the
camera. There are 6 modes of FL control as follows;
0
auto FL
Automatic Flickerless mode
1
50Hz to auto FL
Change to auto FL mode after starting with 50Hz FL mode.
2
60Hz to auto FL
Change to auto FL mode after starting with 60Hz FL mode.
3
50Hz fixed FL
50HzFL fixed mode
4
60Hz fixed FL
60HzFL fixed mode
5
FL off
Off the FL function
The default setting is "5".
DC Iris control level
You can adjust the convergence point of the auto iris when you use the DC iris lens.
The convergence point changes by increasing the value to the opening side and by
decreasing the value to the closing side. Even though the fine adjustment is required
depending on the AE setting and DC iris lens used, basically the default setting (128) is
recommended.
If you want to intentionally make the lens fully open, set the value “255”, on the other
hand, in case of making it fully closed, set the value “0”.
In the range of [0 ~ 255], you switch the set value. The default setting is "128".
DC Iris control speed
You can adjust the convergence point of the auto iris when you use the DC iris lens. By
increasing the value, the convergence speed becomes faster. By decreasing the value,
the convergence speed becomes slower. Please note that increasing the value
excessively causes hunting and overshoot, and it is possible that the diaphragm control
is stopped if the value is too small.
Please find the relevant convergence speed by shooting bright and dark subjects
alternately because the optimum value differs depending on the DC iris lens.
In the range of [0 ~ 255], you switch the set value. The default setting is "31".
