STANDALONE WIRELESS MOTION
SENSOR ALARM
INSTRUCTION MANUAL
Model No: WGWMSA
www.watchguardalarms.com.au
Controls
Battery installation
Alarm Unit
1
The battery compartment is accessed from the rear of the alarm unit
by removing the battery cover.
2
Insert two (2) ‘AA’ size Alkaline batteries (not included), following the
polarity of diagram.
3
When the last battery is inserted the alarm will
BEEP
, indicating that
the batteries are installed correctly.
4
Close the battery cover.
Low Battery Warning
The ‘Battery Low’ indicator will turn on when the batteries need to be
replaced.
Remote Key Fob
The key fob uses 1 x A27S battery (included). If the red LED remains ‘ON’
without pressing the buttons, this indicates a low battery, simply remove
and replace with a new battery.
Installation
1 Place the alarm in the desired location, using swivel wall mount
bracket provided.
2
Fix bracket to the wall using the screws supplied.
Please note that this alarm can also be used free standing.
Learning Key Fob(s) to Main Unit
Learning the remote(s) is done by pressing the “Learning Button” on the
sensor and the “on” button of the key fob simultaneously until you hear
BEEP
2 times, which means the remote has been successfully learnt into
the sensor. Repeat this process to learn additional remotes into the sensor
(maximum of 3 remotes per sensor)
To delete a remote:
Remove all the batteries from the sensor and reinstall them. Begin learning
the required remotes into the sensor, using the steps above.
*
For additional remotes, please contact your local distributor (details
overleaf)
Please note:
Every time the batteries are removed either from the sensor or key fob, the
remote(s) need to be re-learnt into the sensor.
Operation
When exiting the protected area
Simply press ‘ON’ button of key fob within the distance of 30 meters (Line
of Sight) to arm the unit. A confirmation tone
“BEEP”
will indicate that the
alarm is armed and you have 30 seconds to vacate the area. After that, if
motion is detected the alarm will sound.
When entering the protected area
Simply press the ‘OFF’ button of the key fob within the distance of
30meters (Line of Sight) to disarm the unit. Please note that when entering
the area, there is a
short beep
to indicate that motion has been detected
and a 4 second delay to allow the main unit to be disarmed.
Detection range
The motion detector of the alarm unit has a 7-metre (21ft) detection range
with angles of 60º vertical and 110º horizontal approximately.
Care and maintenance
To clean the case, simply use a soft slightly damp cloth with water and
wipe dry immediately.
CAUTION:
Never use chemicals to clean the case, as they may cause
damage to the plastic and cause the alarm not to function.
Troubleshooting
The unit does not sound when the batteries are installed
Ensure that the batteries are in proper polarity
The alarm does not arm
Check key fob red light comes on when the ‘ON’ or ‘OFF’ buttons are
pressed
The red light on the alarm unit is ON
This is an indicator of ‘Low Battery’, which means the batteries need
replacing.
The red light on the key fob does not light up when the buttons are
pressed
Remove the battery cover of the key fob and replace the battery.
Battery precautions
When using this product follow these precautions at all times.
• Use only the appropriate size batteries
• Be sure to follow the correct polarity when installing the batteries as
indicated in the battery compartment. Incorrect polarity may cause
damage to the alarm.
• Do not mix different types of battery such as Alkaline and Carbon-zinc
or old batteries with new.
• If the alarm is not used for long periods of time, remove the batteries to
prevent damage or injury from possible battery leakage.
• Do not recharge batteries not intended to be recharged as they can
overheat and rupture. (Always follow the manufacturer’s directions.)
