Watchguard SSL 1000, Руководство по установке

Страница: 4 / 6

WatchGuard SSL 500 and SSL 1000 Setup
4 WatchGuard SSL 500 & SSL 1000
5
Install WatchGuard Authentication Service
„
Run AuthenticationService.exe .
„
Follow the steps in the wizard to complete the installation.
„
When prompted for the system IP address, type the IP address of the computer on
which you are installing this service.
„
Reboot your computer or use the Windows Control Panel > Administrative Tools >
Services applet to manually start the WatchGuard Authentication Service .
6
Install WatchGuard Policy Service
„
Run PolicyService.exe .
„
Follow the steps in the wizard to complete the installation.
„
When prompted for the system IP address, type the IP address of the computer on
which you are installing this service.
„
Reboot your computer or use the Windows Control Panel > Administrative Tools >
Services applet to manually start the WatchGuard Policy Service .
7
Verify your services are installed in WatchGuard Administrator
„
From WatchGuard Administrator, go to Monitor System > System Status . An error
message appears for any system component that is not running.
„
Reboot your computer.
The default Service ID number is 4.
The default Service ID number is 3.
At this point in the setup process, you see an error that the
Access Point is not running. The Authentication Service and
Policy Service should be running. If either of these services is
not running, restart the service.