06.10.21, 10:40
WatchGuard Firebox M290/390/590/690 Hardware Guide
https://www.watchguard.com/help/docs/help-center/en-US/Content/en-US/Hardware-Guides/firebox-m290-390-590-690-hardware-guide.html?cshid=…
8/21
To use the rack rail kit, do not attach the included front ear brackets.
Separate the inner rails from the outer rails.
Attach the inner rails and front ear brackets to the Firebox.
Attach the outer rails to the rack.
Install the Firebox in the rack.
Remove the Firebox from the rack
Interface Module Installation
You can install an interface module in the interface module slot of your Firebox. The supported interface
modules are described in detail in the
Interface modules are not hot-swappable. To avoid damage to the system, power
off the Firebox before you install or remove interface modules.
Install an Interface Module
To install an interface module:
1. Disconnect the power cable from the Firebox.
2. Loosen the two captive screws on the slot cover.
3. Remove the slot cover to expose the interface slot.
4. Insert the interface module into the slot, and push it firmly into place.
5. Tighten the two captive screws on the interface module to attach the interface to the Firebox.
6. Reconnect the power cables to the Firebox.
The Firebox starts automatically. When the Firebox starts, Fireware automatically detects all installed interfaces.
Remove an Interface Module
Before you remove an installed interface module, make sure that the interfaces on
that module are not enabled in the Firebox configuration. You cannot manage a
Firebox if an enabled interface has been removed.
To remove an installed interface module:
1. Disconnect the power cable from the Firebox.
2. Disconnect all network cables from the installed interface module.
3. Loosen the two screws on the installed interface module.
4. Slide the interface module out of the slot.
5. Place the removed interface module on an antistatic surface, or immediately install it in another
slot.
