INSTALLATION
Do not handle internal electronical components whilst wiring up. Environmental
exposure during installation should be under dry circumstances, avoid heavy moist
and wet conditions.
To open the Housing please first remove the hexagon m3 bolt, then unscrew the
glass top of the housing. To wire the ATEX Beacon remove LED insert by removing
the 3 Nylon screws, and disconnect the LED PCB from connector J3.
Connect Power Supply and signal or Modbus cables to the J9 or J4 connector. Se-
lect if you want to use the beacon analogue or controlled by Modbus.
ANALOGUE CONTROLLED
Select the if the trigger is positive or negative trigger by setting the Jumper to the
right position. Select the mode and patterns for each used colour by according the
DIP switch settings figure. Connect the trigger wires to the correct terminal.
NOTE: Colours are prioritised Lowest blue>green>yellow>Red Highest, so if you
trigger green and red you get a red light.
When connections are made reconnect LED PCB to J3 and fix it with the 3 nylon
screws. Carefully screw back glass to ensure that there’s no cable obstructions
during closing, place back the hexagon bolt.
ATEX Beacon
D e t e c t i o n
M
A
N
U
A
L
