12
Sensor
-
In the Sensor setup the choices are: Temperature in Fahr-
enheit, Temperature in Celsius, Humidity, Wetness, and Voltage.
Using the up and down arrows, toggle between the choices. Once
the desired sensor is displayed, press the SET button. The display
will toggle to Limit mode. Press SET again to enter Limit setup
mode.
Limit
-
The Limit selection determines whether an alarm occurs
when the sensor value becomes greater than or becomes less than
the threshold limit set here. Select Above or Below using the up and
down arrow buttons, then SET to select your choice. The display will
toggle to allow you to set the threshold value. Use the up and down
arrow buttons to change the value and then press the SET button to
select the value shown. The display will toggle to Alert. Press SET
again to enter the Alert setup mode.
Alert
-
The unit prompts for up to four phone numbers you desire to
call and/or text with an alert. To key in a new phone number, use
the up/down arrow buttons, pressing SET after each number once it
is reached.
There is room for four phone numbers of 17 digits each.
Following the last digit of each phone number choose
‘
OK
’ ,
which is
the digit below zero, and press SET which will then continue to the
next phone number. If less than four phone numbers are desired,
select
‘
OK
’
in place of the first digit and press SET. That phone
number and any remaining slots will be inactive.
Note:
In the US
,
entering a
‘1’
before the number is not necessary
with most cellular providers. Outside of the US the prefix required
may vary by country and provider. To delete the current phone num-
ber, use the up/down arrow buttons to go below zero where a back
arrow will
appear
←
. Holding the SET button down will erase all the num-
bers and continue into the previous phone number. Pressing the
SET button temporary will erase the prior number only.
Voice call and text message can each be set to on or off using the
options YES or NO. Use the up and down arrow buttons to choose
YES or NO and press SET. The display will toggle from Voice Call
to Text Message, and then onto the Notify mode. Press SET again
to enter the Notify setup mode.
