Wasserhaus Deutschland GmbH· Max-Wundel-Strasse 12 · D-14469 Potsdam ·
Tel. 0331 – 505 79 43 · Fax 0331 – 505 79 52
www.wasserhaus.de · e-mail: [email protected]
page
13
Some Important Installation Notes
No tools are needed to connect the tubing. Just insert tubing into the fitting all the way. The
RO System uses so-called John-Guest (JG) type fitting or quick-connect fitting. To make a
connection to JG type fitting, cut tube straight and square, then insert tube all the way, and
pull it to lock it.
Connecting standard JG type push-in fittings
Connecting standard JG type push-in fittings
(Push up to pipe)
Push the pipe into the fitting, to the pipe stop. The collet (gripper) has stainless steel teeth
which hold the pipe firmly in position whilst the 'O' Ring provides a permanent leak proof
seal.
Pull on the pipe to check it is secure. It is good practice to test the system prior to leaving site
and/or before use.
Disconnecting standard JG type push-in fittings
Disconnecting standard JG type push-in fittings
(Push in collet and remove tube)
Ensure system is depressurized before removing fittings. Push in the collet against the face
of the fitting. With the collet held in this position the pipe can be removed. The fitting can then
be re-used.
Installation
Your RO system is made for installation under the sink, in a basement or other location,
depending on available space. Do not install unit where temperatures fall below freezing;
otherwise, damage will result.
We recommend you to call a plumper to have your system professionally installed. WRONG
MOUNTING MAY RESULT IN WATER DAMAGE IN YOUR HOUSE! The connecting parts
have been proven a million fold and are standard compliant. If you would like to have
different connecting parts, you can buy them in our store or at every specialized dealer.
