3
pipe. Subsequently, put Cap 3 back into the pump turning it to the right (clockwise) and tighten it by hand. Check the tightness
of Drain Cap 4. Excessive tightening with pliers may result in damaging the cap. Immerse the suction hose suction strainer
into the water source needing to be pumped. After pumping is completed, any water remaining inside the pump must be
drained by unscrewing Cap 4. Storing the pump filled with water over a long period of time will cause internal corrosion on the
pump blades and scale on rotating parts, therefore, reducing the pump’s life.
Start the engine and adjust the engine speed with the throttle. Refer to the ENGINE section for more information on
starting the engine. It’s necessary for the engine to run at higher revolutions until the pump takes in water from the
source. The suction process can be seen through a transparent suction hose. If the pump doesn’t exert pressure
within 30 seconds after starting the engine, turn-off the engine and follow the Troubleshooting instructions.
CAUTION: Draining water from a depth of more than 3 metres may require water replenishment to the pump as
described in the Putting in Operation section.
Dry running for more than 60 seconds will cause pump damage! WARNING: If the pump
takes in air, it’s necessary to remove the leakage on the suction pipe and repeat the
whole process of pouring water into the pump.
Damage caused to equipment due to non-
compliance with this instruction the warranty will be deemed invalid.
Engine
The engine
MUST
be filled with the correct amount of engine oil before its first
commissioning. For specifics refer to the Technical data section. Set the pump on a
horizontal surface. Open the oil sump plug, also fitted with the oil gauge. Fill the engine
with approximately
¾
of the oil amount required. Screw the plug back into the oil sump.
With the
C
switch se to the
OFF
position (see the figure below), cycle the engine by
pulling the starter cord. Remove the plug, wipe the gauge dry and check the engine oil
level.
CAUTION:
To get the correct reading, the gauge must be fully screwed in place. Top
up the oil to achieve the final level between the MIN and MAX marks.
Remove the plug and fill the tank with petrol carefully. To ensure full performance of the
engine, use fresh petrol with the octane rating of 91 or higher. The physical properties of
old and vapid petrol are different and it may cause an uneven run of the engine or reduced pump performance.
Use clean and oil-free petrol only - your engine is a four-stroke type.
DANGER
When in operation, the engine
produces carbon monoxide,
which is a colourless and odourless poisonous gas. Inhalation of carbon monoxide may cause nausea,
headaches, dizziness, vomiting or even death! The device may be used outdoors only, with proper
ventilation ensured. It is also necessary to prevent ingress of exhaust gases into enclosed rooms via
unsealed openings. When working with the engine on, turn the device in such direction, where the
Výstupnú prírubu tlakovej vody je
možné otočiť podľa potreby o 90°
vyskrutkovaním 4 skrutiek.
The pressure water output flange
can be turned by 90° if necessary,
by unscrewing 4 screws.
