Wasp WWS100i, Быстрый старт, Страница: 5 / 12

Chapter 2
2 3
BEEP AND DELAY
QSG
3 2
Check the “My device is setup and
ready to be found.” and click Next.
The scanner will show up in the list of
Bluetooth devices found. Select Wasp
Barcode and click Next.
If Wasp Barcode does not show up in the
available devices please check the following:
1. Make sure the scanner is on by pressing
the trigger.
2. If you are using a pre-installed Bluetooth
adapter, make sure the adapter supports HID.
The next step will ask you to setup a passkey
for the device. By default the scanner will not
have a passkey set. Please select “Don’t use
a passkey” and click Next.
You can set a passkey later if you prefer,
see Start/Stop Pin on page 6 for details.
The Complete Wizard screen appears. Just
click Finish to complete.
Once the wizard is complete the scanner will
show up as a Wasp Keyboard. Click OK to
close the screen. You are now ready to use
the WWS100i.
Note: These instructions are for XP users. For instructions on pairing a
device using Win7, please refer to page 5 of the users manual