Wasp WPL25, Руководство пользователя

Страница: 36 / 40

32
WPL25/WHC25 User Manual
5.2 Print Problem
Problem Possible Cause Recovery Procedure
Not Printing
Check if interface cable is well
connected to the interface connector.
Re-connect cable to interface.
The serial port cable pin configuration
is not pin to pin connected.
Please replace the cable with pin to
pin connected.
The serial port setting is not
consistent between host and printer.
Please reset the serial port setting.
The port specified in the Windows
driver is not correct.
Select the correct printer port in the
driver.
The Ethernet IP, subnet mask,
gateway is not configured properly.
Configure the IP, subnet mask and
gateway.
No print on the
label
Label loaded not correctly.
Follow the instructions in loading
the media.
Continuous
feeding labels
The printer setting may go wrong.
Please do the initialization and
gap/black mark calibration.
Paper Jam
Gap/black mark sensor sensitivity is
not set properly (sensor sensitivity is
not enough)
Calibrate the gap/black mark
sensor.
Make sure label size is set properly. Set label size exactly as installed
paper in the labeling software or
program.
Labels may be stuck inside the printer
mechanism near the sensor area.
Remove the stuck label.
Poor Print Quality
Top cover is not closed properly. Close the top cover completely and
make sure the right side and left
side levers are latched properly
Wrong power supply is connected
with printer
Check if 24V DC output is supplied
by the power supply.
Check if supply is loaded correctly. Reload the supply.
Check if dust or adhesives are
accumulated on the print head.
Clean the print head.