Wasp WLR8950, Руководство пользователя

Страница: 7 / 36

Chapter 5
5
Use the Factory Default barcode to reset the scanner to the Default settings.
Factory Default
In order to configure Wasp WLR8950 Scanners, you must familiarize yourself with the setup procedures on the following pages.
The default settings of the Wasp WLR8950 Scanners are identified on each page and clearly marked using an asterisk (*). The
default settings have been preprogrammed for the most common barcode configurations. Use the Setup & Configuration only to
customize the Wasp WLR8950 Scanners settings. If you need to configure the scanner, the default settings will be overwritten. All
the programmed settings are stored permanently in non-volatile memory; therefore, your configuration will be maintained even if the
keyboard power to Wasp WLR8950 Scanners is removed by turning off your PC.
In order to configure Wasp WLR8950 Series Scanners, two basic steps need to be followed:
(1) Locate the group that contains the options to be changed.
(2) Scan the barcode representing the option to be changed.
The scanner will sound two beeps.
To change Minimum/Maximum Length:
(1) Scan the Minimum or Maximum Length barcode.
(2) Scan a 2 digit value from the ASCII table on pages 27-30.
(3) Scan the Minimum or Maximum Length barcode again.
Example: To have a minimum length barcode of 1, you must scan a 0 then 1, then scan the minimum barcode again. To have a
maximum length barcode of 10, you must scan a 1 then 0, then scan the maximum barcode again.
Setup & Configuration
Factory Default