Wasp Wasp WDI7500, Руководство по продукции

Страница: 82 / 310

Enter/Exit Programming Mode
72 Wasp WDI7500/WWS750
Good Read LED Duration
Specifies the amount of time that the Good Read LED remains on following a
good read. The good read LED on time can be set within a range of 100 mil-
liseconds to 25,500 milliseconds (0.1 to 25.5 seconds) in 100ms incre-
ments. A setting of 00 keeps the LED on until the next trigger pull.
See
page 251 in “References” for detailed instructions and examples for set-
ting this feature.
$CLAGL00(CR)
Good Read LED Duration Setting =
Keep LED on until next trigger pull
$CLAGL
Select Good Read LED Duration Setting
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE barcode above, then the bar-
code at left followed by the digits from the Alphanu-
meric characters in
Appendix D, Keypad
representing your desired character(s). End by scan-
ning the ENTER/EXIT barcode again.
Make a mistake? Scan the CANCEL barcode to abort
and not save the entry string. You can then start
again at the beginning.
~
CANCEL
DEFAULT
003 = Good Read LED

stays on for 300 ms.
Indicators are dimmed during sleep.