Wasp 2D, Справочное руководство

Страница: 34 / 200

Output
3-10 DuraLine™ 2D Imagers
Illumination Lights
If you want the illumination lights on while reading a bar code, scan the
Lights On bar code, below. However, if you want to turn just the lights
off, scan the Lights Off bar code.
Imager Time-Out
Imager Time-Out powers down the imager after the unit has been idle
for the specified time. To prevent the imager from powering down, set
this time-out to 0. Scan the bar code below, then set the time-out by
scanning digits (from 0 - 999,999 ms) from the
Programming Chart on
page B-5
, then scanning Save . Default = 120,000 ms.
NOTE
This setting does not affect the aimer light. The
aiming light can be set using Aimer Mode (see
Aimer Mode on page 3-12
).
Lights Off
* Lights On
Imager Time-Out