Wasp 2D, Справочное руководство

Страница: 29 / 200

Trigger Modes
Product Reference Guide 3-5
Manual Trigger, Low Power
The imager powers down until the trigger is pulled. When the trigger is
pulled, the imager powers up and operates until there is no triggering for
the time set with the
Low Power Time-Out bar code below. There is a
delay of up to one second in operation when the imager is first triggered,
but there is no delay when operating in low power time-out mode.
Low Power Time-Out Timer
Scan the Low Power Time-Out bar code to change the time-out dura-
tion (in seconds). Then scan the time-out duration (from 0-300 sec-
onds) from the
Programming Chart on page B-5
, and Save . Default =
120 seconds.
If the unit remains idle during the low power time-out interval, the unit
goes into low power mode. Whenever the trigger is enabled, the low
power time-out timer is reset.
NOTE
This time-out does not begin until the imager
time-out setting has expired.
Manual Trigger, Low Power
Low Power Time-Out