Pairing Wasp’s Bluetooth scanner models: WWS100i, WWS150i, WWS250i, WWS550i
Page 2 of 2
This page is for use only with a pairing code or Pin.
9. Click “Create a pairing code for me”, “Choose a
passkey for me”, “Or, try entering a passcode on
it”, or similar verbiage.
Windows 7:
Windows 8 (click the link below the box):
Notes:
• Do not enter the example code from
Steps 10 or 12, since your code will be different.
10. A pairing code will appear. Example:
11. Scan
12. For each digit in the code shown on your
screen, scan its corresponding barcode (below).
For example, if your code is 15492208, start by
scanning the barcode for 1, then the barcode for 5,
then the barcode for 4, etc. until you have scanned
all digits in the code, then continue.
13. Scan the Enter barcode (below). Windows
should begin to install the device.
Continue with the procedure.
14. Scan Stop Pin (below). Go to Step 7.
• Do not scan all the barcodes below in order; instead match each code digit to a barcode digit (Step 12).
• Maintain a brisk pace; Windows times out quickly. If so, click Try Again, then go back to Step 11 (Start Pin).
• You should hear only one beep per digit barcode. If there are three beeps, go back to Step 11 (Start Pin).
• Don’t forget to scan Stop Pin in Step 14.
version 20180831
