Wascomat Giant W 185, Руководство по эксплуатации и техническому обслуживанию

Страница: 20 / 56

13
Function control check-out list
In the machine cylinder, you will find the warranty
registration card, a copy of the warranty policy
and other pertinent materia. The warranty card
should be completed and sent to Wascomat. All
other items should be placed in a safe place for
future reference.
The machine should be cleaned when the instal-
lation is completed, and checked out as detailed
below without loading the machine with fabrics:
1. Check the incoming power for proper voltage,
phase and cycles.
2. Open manual shut-off valves to the machine.
3. Turn on electric power.
4. Check the function of the door safety interlock
as detailed on page 10 of this manual.
5. Select the HOT program and start the
machine.
6. Run through a complete cycle, checking for
water temperature, drain operation and extract
direction.
7. When the program is in the Prewash cycle,
hot and cold water should be entering the
machine. In the Wash cycle only hot water
should enter.
8. If cold water comes in, the hoses are impro-
perly connected. Reverse hot and cold water
hoses.
9. Machine must spin in a counter-clockwise
direction, as seen from the front, during extra-
ction. If it does not, reverse lines L1 and L3 on
3-phase machines.
If the side panels of the washer move during
extraction, remove the shipping security which
connects the top rear of the cylinder to the
upper section of the back panel. It is used to
prevent shipping damage but has no function
when the washer is installed in a laundry. In
some rare installations this bracket may
transmit vibrations to the side panels. If it
does, remove the shipping security; otherwise,
leave it in place.
NOTE
All machines are factory tested prior to
shipment. Occasionally, some residual
water may be found when the machine is
installed.
Installation
17
1189
1835
1836
20
1190
18
19
Fig.
17
Fig.
18
Fig.
19
Fig.
20
Delicate
Hot
Cold
Warm